Great! its encouraging to know that it does work. I have imaged it to a microsd and put it in. i also have a generic WiFi adapter that uses the Ralink RT5370 chipset which is on the list. i also put a small usb drive in fat32 format on it. Do i just Image the chip and run the pi or do i need to do stuff? i have tried using the image but i always ssh'd to it or plugged it into a screen. can i just image it and run? surely id have to at least log in right? I have done the manual install and used the image, both from you. Except i don't know what an AP is. Access point perhaps? If that is what you're asking yes i have rebooted several times and tried the manual install to no avail. I have tried both methods many times. My question is this: when using the image do i simply plug it all in and let it run or must i log in to the PI? is there not some sort of start command that needs to be given? same goes for the manual install. do i just reboot and it works? because i am yet to see the access point. i have given it warm up times and tried different devices to connect. i need to know what to do after i set up the image.
↧